Give the joint added strength.
Use BTG-500 where matching EPP push-fit components need additional joint rigidity. Plan the assembly before applying adhesive so the connections can be completed in the intended order.
Recent
Clear
BlauTHERM BTG-500 is a 500 ml solvent-based EPP joint adhesive for adding strength and rigidity to compatible insulated ventilation duct connections.

BlauTHERM
Finish compatible EPP duct joints with BlauTHERM BTG-500 adhesive. The 500 ml tin is intended for matching insulated ventilation duct components where the installation calls for additional joint strength and rigidity.

Choose the matching components, prepare the connection and allow for the specified adhesive process.
Use BTG-500 where matching EPP push-fit components need additional joint rigidity. Plan the assembly before applying adhesive so the connections can be completed in the intended order.
Coordinate the adhesive with clean mating surfaces, fully assembled connections and suitable duct supports. Follow the manufacturer's application and cure instructions for the actual joint.
Use with compatible BlauTHERM insulated duct components.
Strengthen the assembled connection to suit the installation.
Order using the clear BTG-500 product code.
Check the connection dimensions before estimating consumption.
Provide suitable supports alongside the bonded connections.
Confirm the method, working time and cure conditions before use.
Confirm the manufacturer's application and safety instructions before starting. The sequence below is a planning guide.

Check compatibility and the mating arrangement, and dry-position the components before applying adhesive.
Follow the manufacturer's surface-preparation instructions. Check the cut ends and mating surfaces before assembly.
Use the specified quantity and method. Join and hold the components as directed, within the confirmed working time.
Observe the specified cure conditions before handling, loading or commissioning. Maintain suitable duct supports.
Use with compatible EPP joints, with the application method and curing conditions confirmed before use.
Read the current manufacturer's Safety Data Sheet before use.
Safety panel awaiting the supplier SDS. Final pictograms, signal word, hazard statements and precautionary statements must be added before publication. These general precautions are not a substitute for the statutory product label.
It is an EPP joint adhesive for adding strength and rigidity to compatible matching BlauTHERM insulated ventilation duct components.
BTG-500 is supplied in a 500 ml tin. The number of joints per tin depends on the confirmed application rate and the joint dimensions; no coverage figure is currently supplied.
Use it where the installation calls for added joint strength and rigidity, following the joint design and the adhesive manufacturer's instructions. Fully assemble the matching connection and support the finished ductwork.
The prepared listing is for compatible EPP joints. Do not assume it is suitable for PVC, ABS, rubber seals, coatings or other materials without the manufacturer's confirmation.
Yes. Plan suitable ventilation and handling, and read the current manufacturer's Safety Data Sheet before use. The test report does not establish a complete hazard classification.
The manufacturer's application and curing instructions are still required. Do not rely on an invented drying time or load or commission the assembly before the specified cure conditions are met.
No. Provide suitable support for the completed ductwork. Adhesive is intended to add joint strength and rigidity, rather than carry an unsupported run.
No. The supplied chemical-content report does not support either description. Use the current SDS and manufacturer's instructions to assess safe handling and the intended application.
| EAN Number | 5056194058896 |
|---|